Initial Update is a one-time processing of all approved Microsoft patches applicable to a managed machine based on Patch Policy. Initial Update ignores the Reboot Action policy and reboots the managed machine without warning the user as often as necessary until the machine has been brought up to the latest patch level. Initial Update should only be performed during non-business hours and is typically performed over a weekend on newly added machines. See Methods of Updating Patches, Configuring Patch Management, Patch Processing, Superseded Patches, Update Classification and Patch Failure for a general description of patch management.
Note: The agent for the KServer is not displayed on this page. Initial Update cannot be used on the KServer.
Patch Update Order
Service packs and patches are installed in the following order:
Note: Reboots are forced after each service pack and at the end of each patch group without warning. This is necessary to permit the re-scan and installation of the subsequent groups of patches.
Agent procedures can be configured to be executed just before an Initial Update or Automatic Update begins and/or after completion. For example, you can run agent procedures to automate the preparation and setup of newly added machines before or after Initial Update. Use Patch Management > Pre/Post Procedures to select and assign these agent procedures on a per-machine basis.
Click Schedule to display the Scheduler window, which is used throughout the VSA to schedule a task. Schedule this task once. Options include:
Click Cancel to cancel execution of this task on selected managed machines.
Select All/Unselect All
Click the Select All link to check all rows on the page. Click the Unselect All link to uncheck all rows on the page.
These icons indicate the agent check-in status of each managed machine:
Online but waiting for first audit to complete
Agent online and user currently logged on. Icon displays a tool tip showing the logon name.
Agent online and user currently logged on, but user not active for 10 minutes
Agent is currently offline
Agent has never checked in
Agent is online but remote control has been disabled
The agent has been suspended
Note: Displays the following message if applicable:
This timestamp shows the scheduled Initial Update.
If checked, an Initial Update has been performed successfully on the machine ID. The timestamp shows when the Status being reported was completed.
During processing, the Status column displays the following types of messages, if applicable:
When all processing has been completed, the Status column displays either:
If the latter status displays, select the appropriate machine ID in Patch Management > Machine Update to determine why all patches were not applied. Some patches might require manual install or for the user to be logged in. In the case of patch failures, manually schedule failed patches to be reapplied. Due to occasional conflicts between patches resulting from not rebooting after each individual patch, simply reapplying the patches typically resolves the failures.